README

1. Install StreamX Connector in Magento

cd $MAGENTO_ROOT_DIR
bin/composer require streamx/magento-connector-php

Note: if the command asks you for a github access token - just press ENTER

2. Perform steps to enable the Connector's modules in Magento

cd $MAGENTO_ROOT_DIR
bin/magento module:enable StreamX_ConnectorCore
bin/magento module:enable StreamX_ConnectorCatalog
bin/magento cache:clean
bin/magento cache:flush
bin/magento setup:upgrade
bin/magento setup:di:compile

3. Start your StreamX instance (or verify it's already running)

streamx run -f path-to-your-mesh-file

You can find a basic mesh file at src/catalog/test/resources/mesh.yaml

4. Enable and configure StreamX Connector via the Magento Admin page

• Click on STORES on the left panel
• Click Configuration in the Settings area
• Expand STREAMX section, click on Connector item, then expand General Settings section on the right
• Select Yes for the Enable StreamX Connector setting and click the Save Config button
• Switch Scope to website and select stores on the List of stores to reindex
• Expand StreamX Ingestion Settings section below
• Edit the settings you need, or leave the default values
• Click the Save Config button
• You can also provide separate values for StreamX Ingestion Settings for each store

5. Verify the Connector by indexing and publishing all categories to StreamX

cd $MAGENTO_ROOT_DIR
bin/magento indexer:reindex streamx_category_indexer

6. Verify if the data has been published to StreamX

If you used the src/catalog/test/resources/mesh.yaml to set up your local StreamX instance, you can verify if the categories were successfully published to StreamX.

To do so, open your StreamX instance's Web Delivery Service endpoint in a web browser and verify the JSON output at a category URL. Sample URL for Category with ID 6 is: http://localhost:8081/cat:6 Note: if you used a different Mesh Yaml file, the URL will be different.